정비 사례

Good afternoon all. My car, a 1997 Toyota Corolla has developed a problem I’m hoping maybe someone can help me figure out. Lately I’ve had a plethora of work done to the car. I’ve had the gas tank, fuel pump, all four struts, main oil seal, plugs, wires, cap, rotor, transmission fluid/filter, motor oil/filter etc, all replaced. The car actually runs pretty good, except, after having the main oil crankshaft oil seal replaced, the car has developed a problem. It feels like I got bad gas but I don’t think that’s the problem. If I press too hard on the accelerator, the car wants to stall. If I tak

토요타 캠리

2018년식 · ACV70 (2017-현재) · 2.5 자동

브레이크 디스크 교환

IF YOU SLOW TO A ROLL THEN TRY TO ACCELERATE, IT JERKS REAL BAD LIKE IT DOES NOT KNOW WHAT GEAR TO GO INTO. TAPPING FROM THE ENGINE BAY THAT COMES AND GOES. THE BRAKE ASSIST FEATURE CAUSE MY ROTORS TO GET WARPED RIGHT AFTER REPLACING THEM. LANE KEEPING ASSIST WILL YANK YOU OVER INTO A TURNING LANE IF YOU AREN'T SUPER CAREFUL.

I just hand my 1995 Jeep Grande Cherokee 4.0L straight 6 automatic in for tune-up (rotor, cap, wires, plugs, filters oil etc) and trans fluid service at special jeep repair shop. Also had the motor mounts and front suspension arms with bushing replaced four days after the tune up and trans service. Now after the tune-up and trans service was complete and prior to replacing the motor mounts I immediately notice more pronounced vibration in the steering wheel when stopped at a light. Take it out of gear and place in neutral while stopped at the light and it gets better but not totally gone. The

포드 F-150

14세대 (2021-현재) · 2.7T XLT

브레이크 디스크 교환

I found out today I need to do the brakes on my f150. I went amd got pads and rotors before the ford dealer closed. But when I started i realized I should probably replace the calipers too. So I have a question, should l wait until Monday and get motorcraft from the dealer or go pick up some carquest premium ones from advance auto? I can live without the truck for a few days but id like to finish it up too. Im guessing motorcraft is reman like the carquest. What do you all think?

What are the visual signs that brake rotors must be replaced?

How much disc brake drag is acceptable?

Rotor Replaced and MY Car is only 3 years old

Do I really need a lathe to turn my rotors?

Disc brakes don't stop!

How do parking brakes acting on disc brakes work?

brake squeal and grinding rotor even if I had just installed new pads

Front wheel bearings integral to rotor assembly

New pads and rotors, left side squeaks when turning right

Is a rubbing disc brake dust cover the first symptom of a bad wheel bearing?

Stator and Rotor vs Magneto

Sounds like brake disc is making contact with pad shims

Rust on rotors after non-use, mechanic said they need to be replaced

Car shakes when braking: warped rotors or alignment?

What can cause perfect holes in brake rotors?

Mechanic sent me this image and said my brake rotors should be replaced. Does this seem right?

What can cause warped rotors?

brake rotors- blank, slotted or drilled?

When do brake rotors really need to be replaced?

What causes brakes to pulsate right after rotor and pad replacement?