혼다
변속기 오일 교환PistonHeads★ 신뢰도 4.1 (높음)

혼다 어코드 수리 사례

2004년식 · CL/CM 7세대 (2002-2007) · 2.4 LX

총 비용

-

공임

-

부품비

-

소요 시간

-

2026. 10. 27. 작업

난이도 & 준비물

난이도 보통⏱ 예상 60~120분🔧 리프트

증상

TL;DR: I have bought this:My wife is vaguely supportive of this idea. It is a 2004 7th Gen Honda Accord Tourer in a rather fetching blue but, more importantly, the 2.4 VTEC engine and a 6 speed manual gearbox. The Full Story With my beloved MG ZTT 260 off for extensive refurbishment, I remembered last time it was 'away' was for 6 months. We are at present nearing the end of an extensive house renovation, with only an Alfa Romeo GTV and a Honda Insight in regular use outside. The utility of an estate car cannot be overstated, and given the number of trips to buy tiles, sinks, get the dump, move

처리 내용

Thanks everyone for the messages - I wondered if this would be a PH-worthy car but as always, the Readers' Cars section once again proves itself as one of the better places on the internet.Please do send over breakers, parts and specialist recommendations - I am amassing details but it seems a lot of you have good stories and experiences on these to share!Cambs_Stuart said: VTECH YO!Great purchase (as always). What's the engine like? How are these for rust? Always thought these were a handsome workhorse. Hope it does you well. YO! Love it! VTEC at 6k sadly - you really need to push it but it does work as expected. During the test drive there was a quiet pause after it engaged, and the seller just said wistfully "I'm going to miss that".Yes, they do rust, and this one has bits and bobs but is remarably clean underneath. I am itchign to get it properly clean and poke it about but I prodded as much as I could while buyign and the seller sent some great photos of it on a ramp before I journeyed up. More to follow...danb79 said: Great car & engine!Decent all season tyres too; some money spent on it clearlyA set of Bremtech discs and pads all round (or Blue Print, Brembo etc) and a fluid refresh; the brakes will be spot on then The K24s a good engine too; any idea of its ever had a chain replacement or when it last had valve clearances done?Yes the new set of Goodyers with zero wear and recent bill was a key factor - not cheap and I have never, ever bought a car that I didnt have to immediately take to a tyre place. This is a first for sure!Discs and pads all round - no driveway or garage at present but hopefully I can soldier it on until that and the weather resolves itself.No idea on the engine - I didnt ask but I need to go through the stack of bills. It is also usign a bit of coolant - no head gasket issues apparent and there is a damp radiator (its hard to tell in this season) so I'm goign to investigate all connectors and junctions.ziggy328 said: My wife’s car is

출처

이 사례는 PistonHeads에서 수집한 데이터입니다.

신뢰도 4.1점(높음) — 출처 소스의 전문성/검증구조를 기준으로 산정된 점수이며, 정확성을 보장하지 않습니다.

원문 보기 ↗

혼다 어코드 다른 정비 사례

1.5T AWD

혼다 디오 110 (Dio 110) | 프론트 스태빌라이저 장착 | 공정1: MBX125F의 프론트 펜더를 구해서 낙찰받았습니다. 연식에 맞게 낡긴 하지만 상처나 균열이 없는 양품인 것 같습니다. 휠 지름이 JF31에 가까운 16인치라면 유용성도 높고 도움이 됩니다. 그런데 16인치 휠이라니 정겹습니다. 86년경까지는 프론트 16인치 휠이 온로드 바이크의 주류였거든요. NS250R이나 RG250Γ 같은 모델들 말입니다. | 공정2: 도착한 프론트…

1.5T AWD

ホンダ ステップワゴンスパーダ(RP6/7/8)|SYNCHRO WEATHER 溝深さの記録・ローテーション(約10ヶ月後走行5,621km)|工程1:外側 約6.2mm 新品比-0.8mm|工程2:内側 約5.2mm 新品比-1.8mm|工程3:プラットフォームまで 約2.8mm 新品比-1.2mm|工程4:前後ローテーションしました ODO:13,205km|工程5:リアからフロントへまわしたタイヤ 外側 約6.8mm 新品比-0.2mm|工程6:リアからフロントへまわしたタイヤ 内側 約…

1.5T AWD

혼다 N-ONE(JG3/4) | BLITZ 엔진후드 댐퍼 장착 | 공정1: 이전에 구입한 BLITZ 엔진후드 댐퍼를 장착했습니다. 10mm 렌치와 드라이버, 니퍼가 필요합니다. | 공정2: 로트 차이로 인해 설명서가 다를 수 있습니다. | 공정3: 선배 정비사분들의 정비기록을 많이 읽어서 초보자인 저도 쉽게 장착할 수 있었습니다. 흑백 사진 설명서로는 방향 확인이 좀 어렵네요😄 감사합니다🙇 | 공정4: 본넷 측…손으로 조임😅💦 | 공정5: 작업 중…

1.5T AWD

혼다 N-BOX 커스텀(JF5/6) | 오일 교환. | 공정1: 작업 사진은 촬영을 빠뜨렸습니다😅 이전 7월25일 1년 점검 시 오일 교환 후 38196km 주행하며 교환하게 됩니다. 항상처럼 폐유가 떨어지는 것을 기다리며 진행합니다😊 고마운 일이지만 매번 오일 교환 안내 알람이 조금 번거롭네요😓 | 공정2: 모틸 5w-30

다른 차종의 변속기 오일 교환 사례