변속기 오일 교환 수리 사례

차량 정보 없음

2010 Vauxhall Astra에서 1단, 2단 기어에 진입할 때 물리적으로 막히는 느낌이 남. 기어 스틱의 트리거(보통 후진에 사용)를 들어올리면 1단, 2단에는 진입 가능하지만 후진 기어를 찾을 수 없음.

스바루 레거시

My 2018 Subaru Legacy 3.6R has a CVT, and I have wondered why it is programmed to change ratios in discrete steps (like a conventional automatic transmission would) rather than varying continuously. I see a couple possibilities in the comments and answers to this prior question: CVT on 6 cylinder cars If the ratio varies continuously, it feels and sounds odd to a driver used to conventional transmissions ("like a car with a slipping clutch"). There's greater wear on the transmission during ratio changes, so limiting the frequency of changes improves reliability. Is it likely one of t

차량 정보 없음

I need to make some gears/pinions myself. I have access to a high quality 4-axis CNC mill, but not to a lathe. I'd like to cut these gears out of flat stock (facing), rather than round (edgewise) using narrow end mills. Being able to prototype this in plastic sheets is important to me. I've found a bunch of sites that explain hobbing and that have formulas for pitch etc, but no sites that actually generate the splines for the gear teeth to turn into Gcode. Before I sit down with Mathematica and derive it from first principles, does anyone know of a good resource for this?

쉐보레 말리부

1997 Chevy Blazer 4WD 4.3L V6 - 트랜스미션 팬에 구멍이 있어서 누유 발생