지프 랭글러 수리 사례
JL (2018-현재) · 2.0T 자동
총 비용
-
공임
-
부품비
-
소요 시간
-
2026. 7. 1. 작업
난이도 & 준비물
증상
I have a 93 Jeep Cherokee, 6 cylinder, manual. It starts with no problems. After starting, I can turn the wheel left with no issues, but it is hard to turn the wheel right. I have to give it a good pull and then it will turn. It does not matter if I turn left first or turn right first. The first time I turn the wheel right at all, it sticks. After the first turn right, I don't have any more problems with it. Or, at least I thought not... My drive home is about 30 minutes on a straight highway. I don't turn the wheel more than lane changes during this time. The first time I really "turn" right
처리 내용
It sounds to me the steering gearbox is having an issue. If the valve which controls which way the fluid is flowing to provide the assist is sticking when you first turn right, then it may be hard to turn the wheel. Once you've turned it for the first time it might then become unstuck, allowing things to operate normally. With turning off the highway and the engine stalling, it is conceivable, if the steering gearbox decided not to allow power fluid to go through the gearbox, but instead caused a feedback into the pump, it may be this caused your engine to stall. While this is conceivable, I find it highly unlikely. I feel as though the two incidences are not related, but I wouldn't rule out the steering gearbox causing both. In this case, I'd see what could be done with the steering gearbox and then see if the stalling ever occurs again.
출처
이 사례는 Stack Exchange (미국)에서 수집한 데이터입니다.
신뢰도 2.8점(참고용) — 출처 소스의 전문성/검증구조를 기준으로 산정된 점수이며, 정확성을 보장하지 않습니다.
원문 보기 ↗지프 랭글러 다른 정비 사례
2012 Jeep Compav compass I noticed a persistent squealing coming from thr front end of my car (I think the front left). It happens when I have my foot on the accelerator and over 40-45 mph. It stops when I let my foot off the gas, and only occurs under load. This alone would take me to the engine, but it responds to me turning the wheel. It gets louder when turning right and quieter when left. It also stops when I let off gas. My original thought was brakes, but I wanted to see if the community had an idea. Thanks!
My 2016 Jeep Grand Cherokee limited with a 3.6L started taking a few seconds to start. Ran a scan and there’s no codes.
I need your opinion for a bud. About five months ago, I took my 2014 Jeep Cherokee to a mechanic I hadn’t used before (I’m new to the area). They told me the transmission needed to be replaced. They said they sourced one from a parts dealer and that several other components had to be removed or replaced to install it. The total came to a little over $4,000. Since then, I’ve barely driven it due to health issues. Last week, I tried to go to church. When I shifted into reverse, it was very rough—just like before the replacement. Then I put it in drive and it got stuck in neutral. I called the sh
2016 Jeep Grand Cherokee, 3.6L. I have what sounds like a grumbling or growling sound when I accelerate onto the highway. It’s only presenting when I am heavy on the gas. Stops once I let off. Nothing when turning or stopping. And I put it up in the air and checked the bearings and they all seem solid. It idles quietly. I’m at a bit of a loss…
다른 차종의 정기점검 사례
차량 정보 없음
Hello! I have not driven my car for a month and now have this noise. It is a 2016 V Jetta and normally in great shape. The noise is in the background and sounds like something soft is rubbing against something. It picks up at 10 mi/hr or so and then stays on…Thank you! https://global.discourse-cdn.com/cartalk/original/3X/3/f/3f6ae6628ea80cf8d6b1899d0b2392d868545516.mp3
차량 정보 없음
i looked in my hood and noticed this serpentine belt. does it need replacement? it’s not making any squeeking noises car runs fine for being about 16 years old. IMG_4074 1920×2560 686 KB
닛산 알티마
Power seat - Whenever vehicle is started or shut off and the seat slides forward of back, the power seat makes an annoying, obnoxious noise… I thought something was stuck in the track but now I think it’s the motor going out. Guy at the local dealership said it just needed grease. He appears to be incorrect. Any thoughts? Thoughts?
차량 정보 없음
A buddy and I were trying to replace his right front wheel hub, on his 2008 Chevy Impala LTZ. He described the engine size as 3900, I would think that means 3.9 liter, although I didn’t know there is a 3.9, I only know of the 3.8 liter and 3,1 Liter. One of the mounting bolts is so tight that the socket would not keep a grip on the bolt head, no matter how hard we tried to force the socket onto the bolt head. We had tapped on it as best we could with a hammer and metal rod, we heated the area with a torch, no luck. Of course, very little access to this bolt head, so impossible to use an impact