폭스바겐
정기점검PistonHeads★ 신뢰도 4.1 (높음)

폭스바겐 제타 수리 사례

BU (2018-현재) · TDI 2.0

총 비용

-

공임

-

부품비

-

소요 시간

-

2026. 10. 28. 작업

난이도 & 준비물

난이도 쉬움⏱ 예상 60~120분🔧 전용 진단기

증상

I've threatened to do this so here goes, I've got my anti-EV flame suit buttoned up and gone and leased a new Ford Explorer EV.It's an Extended Range Select rwd in Rapid Red and it arrived this morning.Any questions fire away. One little nugget though, it's on staggered wheels, 235 front and 255 rear. I don't know of any 'normal' car with that outside of say a 911 or the like.

처리 내용

samoht said: Looks good in red, how does it drive?On the tyre sizes, ordinary petrol cars have the heaviest component, the engine, mounted ahead of the front wheels. This gives a front-heavy weight distribution (55-60% perhaps). Thus under lateral load, given equal size tyres front and rear, the front tyres will tend to deflect more from the chosen line, giving stability / understeer, as the fronts have more mass to turn.Most EVs have the heaviest component, the battery, mounted centrally under the occupants. This gives close to a 50/50 weight distribution. (VW states near 50/50 for the closely related ID4). This means that if you fitted equal size tyres, absent any other tuning the tyres would deflect equally at front and rear under equal forces. Put a couple of cases of wine in the boot and you could end up with an unstable car.The wider rear tyres on your Explorer will deflect less from their line per unit of lateral force than the narrower fronts, thus ensuring stability. This is also why things like 911s have wider rear tyres.Thanks for the explanation, it tickled me a bit and as it's fully maintained, I'm not worrying too much about tyre wear.It drives like a rwd car, decent turn in and you can feel being pushed on acceleration, if you know what I mean. I regularly drive front, rear and awd vehicles and this feels very planted and doesn't feel its weight.The screen is a bit gimmicky, however it is useful to move it to eliminate glare and of course the area under the screen is useful for storing sunglasses, etc.Oh, and I like the puddle lamps

출처

이 사례는 PistonHeads에서 수집한 데이터입니다.

신뢰도 4.1점(높음) — 출처 소스의 전문성/검증구조를 기준으로 산정된 점수이며, 정확성을 보장하지 않습니다.

원문 보기 ↗

폭스바겐 제타 다른 정비 사례

TDI 2.0

폭스바겐 T-Cross(C1) | 6년차 점검 | 공정1: 6년차 점검 실시 #매일 점검까지 x일 정보가 번거로웠음 | 공정2: 특별한 이상 없음 | 공정3: 엔진오일 및 필터 교환 #매번 권장되는 엔진 클리닝은 스킵 | 공정4: 키 배터리 교환, 타이어 로테이션, 공기압 F260kPa, R240kPa, 브레이크패드 OK, 배터리 1년 경과로 이상 없음, 구동계/냉각계/하부 등 이상 없음 | 공정5: 연간 약 1만km 페이스...

TDI 2.0

폭스바겐 파사트 세단(B8) | 휠하우스 인너라이너 접촉 회피 대응 및 얼라인먼트 측정 | 공정1: 순정 휠 복구와 동시에 스페이서로 플러시(ツラ合わせ)를 수행했으나, 운전석 측 리어 타이어 숄더 부분에 휠하우스 내 인너라이너가 리어 침하 시 접촉하는 것으로 보이는 스크래치 자국이 간헐적으로 생기고 있음. 다운스프링 등 서스펜션 작업으로 협력해주던 이시카와 엔지니어링에 상담하기로 결정. (작업 시 주행거리: 50,227㎞) | 공정2: 이번...

TDI 2.0

폭스바겐 샤란(2세대) | 에어컨 다이얼 교체 | 공정1: 에어컨 다이얼을 투란 5T 것으로 유용해봤다! | 공정2: 이것도 ついでに ◯ 왠지 이것만 ローレット 사양이 되어있다... 둘 다 되어줬으면 좋겠는데~😭

TDI 2.0

폭스바겐 골프(해치백)(골프7) | 가을 타이어 장착 및 가압식 블리더로 에어 빼기 | 공정1: 날씨가 쌀쌀해져서 가을 타이어를 네오바로 교체합니다. 함께 F 15mm R 20mm 스페이서도 제거합니다. | 공정2: 브레이크 패드 잔량 확인(각 패드 11mm~12mm)하고, 온라인에서 구입한 의심스러운 가압식 블리더로 브레이크 에어 빼기에 도전 | 공정3: 저가형 블리더는 어댑터의 밀착도가 아쉬웠지만 일단 기능하여 에어 빼기(에어는 나오지 않았지만) 완료. 가압 후(1bar, 10psi…

다른 차종의 정기점검 사례