엔진오일 교환 수리 사례

2026. 10. 14. 작업

난이도 & 준비물

증상

I took a flight to Heathrow on Tuesday and drove 420 miles home in a lovely shade of willow green V70 2.5TIt turned over 64,007 when I arrived homeI filled the tank in Slough with 63.4 litres of BP Ultimate and once home OBC says I averaged 33.5mpg (it was at 37.4 before I got stuck in traffic going round Birmingham) and the OBC now says I can still drive another 115 miles. It had a fresh MOT on Monday with a couple of advisories for cracks in the rear tyres. It had an oil change with Shell Helix 0W-30 and genuine Volvo filters.A few niggly jobs to be done but nothing serious.First comfort sto

처리 내용

Thanks the-norseman for your kind words.New cabin filter arrived and fitted in less than 10 minutes, if only everything was as easy...|https://thumbsnap.com/zWtVo9TV[/url]Turned my DRLs off with Vida, why did Volvo not keep the 850 system where you could press a tiny button on the headlamp switch to alternate between on and off, finding it in Vida for the V70 was a PITA.|https://thumbsnap.com/NNhPXTCa[/url]Next I removed the rusty looking bonnet safety catch and my plan was to clean it up and give it a coat of paint. [url]|https://thumbsnap.com/ZhVsdHQZ[/url]I put the catch in an ultrasonic bath and left it for 5 minutes, then another 5 minutes and another 5 minutes, once removed there wasn't much difference so all the Youtube videos must be telling porkies. Into the vice and some emery cloth did a better job then into the sink with steel wool and that was when plan B took place. [url]|https://thumbsnap.com/WXJ7z5zN[/url]I decided rather than paint it a better long term solution was to cover the catch with Lanoguard grease. This isn't a grease for lubrication, it is used on nuts and bolts on the underside of the vehicle to prevent the threads getting rusty. I heated the grease in the microwave (SHMBO was out) and applied it with a brush then lubricated the pin with some 60w oil. Once refitted to the car I used a hairdryer to heat and even out the greaseThe rusty catch has caused some marks on the bonnet, I tried to remove them but was unable, the Lanoguard grease will prevent any further reaction between the two surfaces