닛산 알티마 수리 사례
2018년식 · L33 (2012-2018) · 2.5 자동
총 비용
260,000원
공임
100,000원
부품비
160,000원
소요 시간
90분
2025. 8. 12. 작업
난이도 & 준비물
증상
좌회전 저속 시 틱틱 소음, 악화 중
진단
좌측 전륜 CV조인트 부트 파손, 그리스 누기 오염. 부트 교체 시점 지남.
처리 내용
좌측 드라이브샤프트 어셈블리 교체(리빌트). 우측 부트 점검 정상.
닛산 알티마 다른 정비 사례
Power seat - Whenever vehicle is started or shut off and the seat slides forward of back, the power seat makes an annoying, obnoxious noise… I thought something was stuck in the track but now I think it’s the motor going out. Guy at the local dealership said it just needed grease. He appears to be incorrect. Any thoughts? Thoughts?
I have 2013 Nissan Rogue. I live in Toronto, Canada, so it is very cold here right now. I understand that cold temperatures can cause the tire pressure light to come on, but will it actually affect the reading if I use a pressure gauge (I think that's what it's called) to check the tire pressure? For example, the recommended PSI is about 40 I believe. On Saturday, the tire pressure in all four tires was pretty low so I filled them all up to 41. Now, after leaving my car outside for about two hours, the tire pressure light came on when I started up my vehicle, so I manually checked the pressure
I have a Nissan Qashqai 1.5 dci. My car is not overheating and blowers are blowing cool. The lower radiator hose and the bottom of the radiator are cold. I changed the thermostat and drained the cooling system twice. Still no heat. Any ideas?
다른 차종의 드라이브샤프트 교환 사례
현대 아반떼
Hello! I have a 2010 Hyundai Elantra with 185,000 miles on it. Things are tight financially right now and so I’ve been trying to get this car to last as long as possible before investing in a new one. A year or two ago, a mechanic told me that I needed to get a bunch of work done on my car. We did some of it but saved the front struts and CV axles and are now trying to decide if it’s worth it to spend the money on this. So, I’m asking for some advice from all of you. Is it worth spending the money? Will my car fall apart if I ignore these repairs? I need to get at least another year out of it
혼다 어코드
2020 Honda Accord. I’m now realizing that the lower ball joints use self locking clinch nuts. Have never heard of clinch nuts before. Anyways the service information says to replace them. This is with regards to the lower three nuts that goes onto the studs, as opposed to castle nut that goes on top under the cv axle. See lots of people on youtube doing repairs which requires removing these nuts, and they go ahead and use the same old rusty nuts right back on. image 667×557 32.8 KB Looking online at this type of self locking technology. It is mostly used in sheet metal. A hole is drilled into
혼다 CR-V
I drive a 2014 Honda CR-V. My steering wheel vibrates whenever my car speed is between 30-40 mph. Once past 40 mph, the vibration stops completely. While most explanation mentions about bad CV joint, motor mount, loose lug nuts, unbalanced tires, stuck brake caliper, etc but it doesn’t address the issue as to why it only vibrates between 30-40 mph and not before or after. It is very steady even from 60 mph and beyond. Any idea what is the problem?
차량 정보 없음
Throw out bearing, input shaft bearing, or drive shaft support bearing?